Smart Seal

Smart Seal is the latest and most advanced water based sealer available. It incorporates the latest international technology. It is very simple to use and is suitable for most types of tiles. Smart Seal will out perform any other water based sealer available for ease of application, protection offered and cost effectiveness. Smart Seal is the most cost effective sealer for the following reasons: shortest down time - wash and seal in a few hours (not days). Impregnating sealer - does not change the surface characteristics. Smart Seal is a breathable sealer. That means that it will not fail on application to slighltly damp areas. Smart Seal dries quickly and cures quicker than all other un-accelerated water based sealers. Smart Seal may be used as added stain protection over other decorative water based sealers.

Directions:

Test in an inconspicuous area before continuing the application.

Read all instructions and tips before the application so that you can plan the application correctly.

1. Mask off any adjacent surfaces that need to be protected during the application.
2. Shake very well before use.
3. Ensure that the tile is clean and free from grout, cement, oil, wax and other stains. (Clean with the correct Total Floor Care product if necessary.)
4. Ensure that the floor and grouting are uniformly dry before application. Wait approximately 2 - 4 hours before applying.
5. Using a suitable applicator apply a liberal coat of Smart Seal to the surface. The surface should look wet for 3 - 5 minutes.
6. Allow to dry for 30 min then apply another (thin) coat. Apply more coats at 30 min intervals (if required) until the sealer no longer penetrates and begins to sit on top of the surfaces.
7. Wipe off any excess sealer after 5 min if it does not penetrate.

Instrucciones:

Hacer una prueba en un lugar poco visible para verificar la idoneidad del producto antes de comenzar la aplicación.

Leer todas las instrucciones y consejos antes de su aplicación para que pueda planear la aplicación.

1. Cubrir con cinta las superficies contiguas necesiten ser protegidas del acido durante la aplicación.
2. Agitar bien antes de usar.
3. Asegúrese que el piso este limpio y libre de lechada, cemento, aceite, cera y otras manchas (limpiar con el producto apropiado de Total Floor Care si es necesario).
4. Asegúrese que el piso y la lechada estén uniforme seca antes de aplicar. Esperar aproximadamente de 2 a 4 horas antes de aplicar.
5. Utilizando un aplicador apropiado aplicar una capa liberal de Smart Seal a la superficie. The superficie deberá verse mojado por de 3 a 5 minutos.
6. Dejar que seque por 30 minutos y aplicar otra capa delgada. Aplicar mas capas a intervalos de 30 minutos (si se requieren) hasta que el sellador ya no penetre y empieza a permanecer sobre la superficie.
7. Limpiar el exceso de sellador que no penetra después de 5 minutos.